Cable clip set (15–20 mm)
Snap-fit cable clips tested on PETG and PLA. Print flat with brim if your bed is picky. Works well for desk cable management.
Alice Chen3.8(4)
Printers:Bambu Lab P1S · Prusa MK4 · Creality Ender 3 V3 SE
Models
Filter by printer or search titles and descriptions.
Modular grid drawer organizer
25 mm grid; stackable corners. Scale Z only if you need taller walls. Designed for common EU/US drawer widths.
Bob Novak4.0(4)
Printers:Bambu Lab X1 Carbon · Voron 2.4
Phone stand — minimal
Two-part print, friction fit. Angle ~60°. TPU feet optional for grip.
Maria Santos4.3(4)
Printers:Bambu Lab A1 · Anycubic Kobra 2
VESA 100 adapter spacer
5 mm spacer for monitors with recessed VESA. Use washers; do not overtighten into plastic.
Viktor Lind3.8(4)
Printers:Prusa MK4 · Ultimaker S5
Bench hook — woodworking
Print on side for strength layer lines along the hook. PLA+ or PETG recommended.
Yuki Tanaka4.0(4)
Printers:Creality K1 Max · Rat Rig V-Core 3
RC battery strap holder
Velcro-friendly slots; 3S/4S common sizes. Print TPU body, PETG mounts.
Sam Rivera4.3(4)
Printers:Bambu Lab P1S · Voron 2.4
Shop vacuum hose cuff
Adapter 35→44 mm common shop vac sizes; seal with PTFE tape if needed.
Maria Santos4.3(4)
Printers:Creality K1 Max · Prusa MK4
Keyboard tilt wedges (6° / 9°)
Pairs for split keyboards; rubber bumpers in pockets. Check width before scaling X.
Bob Novak4.0(4)
Printers:Prusa MINI+ · Bambu Lab A1
Plant pot drip tray (120 mm)
Shallow tray with raised ribs for airflow. Resin-printed version available separately.
Alice Chen3.8(4)
Printers:Anycubic Kobra 2 · Creality Ender 3 V3 SE
Filament sample chip holder
Labels face up; 40 mm spacing. Good for swatch libraries.
Sam Rivera4.3(4)
Printers:Prusa MK4 · Ultimaker S5 · Formlabs Form 3 (resin)
Earbud travel case
Latch is print-in-place; run a deburring pass on the hinge after first open.
Yuki Tanaka4.0(4)
Printers:Bambu Lab P1S · Anycubic Kobra 2
Raspberry Pi 4 passive stack case
Tall stack for HATs; ventilation slots on sides. Thermal pad on SoC recommended.
Viktor Lind3.8(4)
Printers:Bambu Lab X1 Carbon · Rat Rig V-Core 3 · Voron 2.4
GoPro-style mount — 30° arm
Use locking nut from hardware store M5; printed threads are for alignment only.
Bob Novak4.0(4)
Printers:Bambu Lab X1 Carbon · Bambu Lab P1S
Door stop wedge (hollow)
TPU or soft PLA; infill 15–20%. Hollow core reduces material.
Alice Chen3.8(4)
Printers:Creality Ender 3 V3 SE · Bambu Lab A1